Factors affecting the output of sand making machine

There are many factors in the use of the sand making machine that will affect its low output, such as material hardness, humidity, finished sand fineness, equipment maintenance and its own quality, etc. Then let's take a look separately:
 
 
   different crushed materials
  Different materials have certain differences in their own hardness, viscosity, humidity, etc., and the amount of sand produced by the sand making machine during crushing will also be different. details as follows:
  The viscosity of the material
   The higher the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the sand making chamber in the sand making machine. If it cannot be cleaned in time, it will seriously affect the work efficiency of the sand making machine, and even the normal operation of the sand making machine. Therefore, when selecting materials, we must pay attention to the viscosity of the materials not too large.
   Material composition
   The more fine powder contained in the material before sand making, the more it affects the sand making, because these fine powders are easy to adhere and affect transportation. Therefore, the material with a large amount of fine powder should be screened in advance, and the fine powder should be screened out from the material as much as possible, so as not to affect the normal operation of the sand making machine.
   Material humidity
   If the water content is high, the materials are easy to adhere when crushed in the sand making machine, and they are also easy to block during the feeding and conveying process, which reduces the sand making capacity.
  To solve this problem, firstly, when selecting materials, we must strictly control the humidity of the materials. If the humidity of the materials is too high, sunshine or air drying can be used to reduce the percentage of moisture in the materials.
  The hardness of the material
  The harder the material, the more difficult it is to make sand, and the more serious the wear on the sand making machine. The sand making speed is slow, and of course the sand making capacity is small. This requires us to be moderate in the selection of materials.
  The fineness of finished sand is different
   The higher the fineness requirement, the finer the material required for sand making, the smaller the sand making capacity. This aspect depends on the specific requirements of the concentrator. If there is no special requirement, generally the fineness of the material can be set to medium fine.
Pre:What to do with the dust generated in the production of jaw crusher? Next:The relationship between the output of the crusher and the motor